2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


CHECK NO. 1 COOLING FAN MOTOR

  1. A169419
    Disconnect the No. 1 fan connector.

  1. Connect the battery and an ammeter to the No. 1 fan motor connector.

  1. Check that the No. 1 fan rotates smoothly, and then check the reading on the ammeter.

    Standard current:
    14.6 to 18.7 A at 12 V

    HINT:
    1. Refer to the indication mark illustration for the indication mark location.
    2. If the result is not as specified, replace the No. 1 cooling fan motor.

  1. Reconnect the No. 1 fan motor connector.


CHECK NO. 2 COOLING FAN MOTOR

  1. A169420
    Disconnect the No. 2 fan connector.

  1. Connect the battery and an ammeter to the No. 2 fan motor connector.

  1. Check that the No. 2 fan rotates smoothly, and then check the reading on the ammeter.

    Standard current:
    14.6 to 18.7 A at 12 V

    1. Refer to the indication mark illustration for the indication mark location.
    2. If the result is not as specified, replace the No. 2 cooling fan motor.

  1. Reconnect the No. 2 fan motor connector.

← COMPONENTS (from May 2007)REMOVAL (May 2007 – Jul 2008) →