2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

B1242 Wireless Door Lock Tuner Circuit Malfunction

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

  1. The electrical key antenna is used to receive electric waves relating to the entry functions of the smart entry and start system. The certification ECU (smart key ECU assembly) decodes the requested smart entry and start system operation by identifying a key code based on electric waves received via the electrical key antenna and the door control receiver.
  2. The door control receiver receives a signal from the wireless door control transmitter and sends signals to the main body ECU through the certification ECU (smart key ECU assembly).
  3. The certification ECU (smart key ECU assembly) then sends a command, according to the requested operation, to each ECU. (e.g. If door lock operation is requested, the ECU sends a door lock command to the main body ECU.)
DTC No.
DTC Detection Condition
Trouble Area
B1242
The certification ECU (smart key ECU assembly) detects that there is a short in the circuit between terminals RSSI, or between terminals DATA and RDA.
  1. Door Control Receiver
  2. Wire harness
  3. Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM

B175266E06

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER)

  1. B175264E09
    Disconnect the D36 certification ECU (smart key ECU assembly) connector and O22 door control receiver connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-39 (RSSI) - O22-2 (RSSI)
    Always
    Below 1 Ω
    D36-38 (RDA) - O22-5 (DATA)
    Always
    Below 1 Ω
    D36-39 (RSSI) - D36-38 (RDA)
    Always
    10 kΩ or higher
    D36-39 (RSSI) - Body ground
    Always
    10 kΩ or higher
    D36-38 (RDA) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
B178823E05
  1. Reconnect the D36 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D36-39 (RSSI) - D36-17 (E)
    Engine switch off, all doors closed, the electrical key is not in the actuation area
    Below 1 V
    Engine switch off, all doors closed, the electrical key is in the actuation area
    4.6 to 5.4 V
    D36-38 (RDA) - D36-17 (E)
    Engine switch off, all doors closed and transmitter switch not pressed
    Below 1 V
    Engine switch off, all doors closed and transmitter switch pressed
    4.6 to 5.4 V



NG
REPLACE DOOR CONTROL RECEIVER (Click here)
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


← DIAGNOSTIC TROUBLE CODE CHART (from Jul 2010)B1242 Wireless Door Lock Tuner Circuit Malfunction (Aug 2008 – Jun 2010) →