2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT STEERING PAD SWITCH ASSEMBLY
  1. Disconnect steering pad switch assembly connector A from the steering pad.

  1. Disconnect steering pad switch assembly connector B from the spiral cable.

    E151678E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    A-1 - B-1 (HO)
    Always
    Below 1 Ω

    If the result is not as specified, replace the steering pad switch assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →