2007-2013 Highlander Kluger · Service Manual ENGINE

B2288 Steering Lock Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output if the main body ECU cannot detect the unlock condition of the steering lock within a specified time.

HINT:
If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2288
After turning engine switch from off to on (IG), the steering wheel does not unlock for a certain period of time (ECU unlocks steering wheel only when it receives an unlock signal from LIN communication and cable)
  1. Main body ECU (Instrument panel junction block)
  2. Steering lock ECU
  3. Wire harness or connector

WIRING DIAGRAM

B176786E07

INSPECTION PROCEDURE


1. CHECK FOR DTCS
  1. Delete the DTCs (Click here).

  1. After all DTCs are cleared, check if the trouble occurs again 18 to 22 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    Result:
    Result
    Proceed to
    DTC B2285 (Steering lock Position Signal Circuit Malfunction) is output
    A
    Steering lock DTCs B2781, B2782 and/or B2788 are output
    B
    DTC is not output
    C



A
GO TO DIAGNOSTIC TROUBLE CODE CHART (DTC B2285) (Click here)

B
GO TO DIAGNOSTIC TROUBLE CODE CHART (DTCs B2781, B2782, B2788) (Click here)
C


2. CHECK STEERING LOCK
  1. Check if the steering lock is released when turning the engine switch on (IG).

    OK:
    The steering lock is released.



NG
GO TO STEERING LOCK SYSTEM (Click here)
OK


3. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Check the DATA LIST for proper functioning of the steering lock function.

    HINT:
    When using the intelligent tester with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.

    Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Str Unlock SW
    Steering lock condition / ON or OFF
    ON: Steering is unlocked (Engine switch on (ACC))
    OFF: Steering is locked (Engine switch off)
    -



NG
REPLACE STEERING LOCK ECU (Click here)
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← B2288 Steering Lock Signal Circuit Malfunction (Aug 2008 – Jun 2010)B2289 Key Collation Waiting Time Over (May 2007 – Jul 2008) →