2007-2013 Highlander Kluger · Service Manual ENGINE

B2289 Key Collation Waiting Time Over

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output if there is a LIN communication problem between the main body ECU and certification ECU (smart key ECU assembly) or when there is a problem in the entry function.

HINT:
If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2289
Either condition below is met:
  1. LIN communication is abnormal between the main body ECU and the certification ECU (smart key ECU assembly)
  2. The engine immobiliser system is malfunctioning
  1. Main body ECU (Instrument panel junction block)
  2. Smart entry and start system (entry)
  3. Wire harness or connector
  4. Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM

B177341E03

INSPECTION PROCEDURE


1. CHECK FOR DTCS
  1. Delete the DTCs (Click here).

  1. Check for DTC B2289 (Key collation waiting time over) and B2785 (Communication malfunction between ECUs connected by LIN).

    Result:
    Result
    Proceed to
    Only "DTC B2289" is output
    A
    Only "DTC B2785" is output
    B
    No DTC is output
    C

    HINT:
    If DTC B2785 is output, perform troubleshooting for DTC B2785 first.



B
GO TO DTC B2785 (Click here)

C
USE SYMPTOM METHOD TO CHECK (Click here)
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)

  1. Disconnect the D36 and 1E ECU connectors.B180496E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1E-7 (LIN1) - D36-10 (LIN)
    Always
    Below 1 Ω
    1E-7 (LIN1) or D36-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the engine starts.

    OK:
    Engine starts normally.

    HINT:
    If the engine does not start, refer to PROBLEM SYMPTOMS TABLE of the smart entry and start system (entry) (Room Oscillator does not Recognize Key).



NG
GO TO SMART ENTRY AND START SYSTEM (ENTRY) (Click here)
OK

END (MAIN BODY ECU DEFECTIVE)


← B2289 Key Collation Waiting Time Over (May 2007 – Jul 2008)B2289 Key Collation Waiting Time Over (from Jul 2010) →