2007-2013 Highlander Kluger · Service Manual STEERING

C1551 IG Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The power steering ECU distinguishes the ignition switch status as on (IG) or off through the IG power source circuit.
DTC No.
DTC Detection Condition
Trouble Area
C1551
IG power source circuit malfunction inside ECU
  1. ECU-IG1 fuse
  2. IG power source circuit
  3. Power steering ECU

WIRING DIAGRAM

C170027E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (IG POWER SUPPLY)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "IG Power Supply" in the Data List and read the value displayed on the intelligent tester.

    EMPS: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG Power Supply
    IG power supply:
    Min.: 0 V
    Max.: 20.1531 V
    11 to 14 V
    Ignition switch on (IG)

    OK:
    The normal condition value is displayed on the intelligent tester.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS

2. INSPECT FUSE (ECU IG NO. 1)
  1. Remove the ECU IG No. 1 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    OK:
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY)

  1. C113533E09
    Disconnect the connectors from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D5-5 (IG) - Body ground
    Ignition switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D4-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)


← C1551 IG Power Supply Voltage Malfunction (May 2007 – Jul 2008)C1551 IG Power Supply Voltage Malfunction (from Jul 2010) →