2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Back Door Entry Lock Function does not Operate

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

If the back door entry lock function does not operate but the back door open function operates, the communication line between the vehicle and electrical key transmitter is normal. As a faulty part, the entry lock switch circuit (certification ECU (smart key ECU assembly) → back door opener switch (entry lock switch)) can be considered.

WIRING DIAGRAM

B171362E02

INSPECTION PROCEDURE

NOTICE:
Before performing the inspection, check that there are no problems related to "CAN COMMUNICATION SYSTEM" and "LIN COMMUNICATION SYSTEM".


1. CHECK POWER DOOR LOCK OPERATION
  1. When the door control switch on the master switch assembly is operated, check that the locked doors unlock (Click here).

    OK:
    Locked doors unlock.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM (Click here)
OK


2. READ VALUE ON INTELLIGENT TESTER (BACK DOOR OPENER SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the tester on.

  1. Select Tr/B-Door Lock SW in the Data List and read the tester display.

    Entry & Start (Certification ECU (Smart Key ECU Assembly)): 
    Tester Display
    Measurement Item/Display
    Normal Condition
    Diagnostic Note
    Tr/B-Door Lock SW
    Back door lock switch / ON or OFF
    ON: Back door lock switch is pushed
    -
    OFF: Back door lock switch is not pushed

    OK:
    On the tester screen, each item changes between ON and OFF according to the chart above.



NG
Go to step 3
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

3. CHECK BACK DOOR OPENER SWITCH

  1. B171360E01
    Remove the back door opener switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Lock switch pushed
    Below 1 Ω
    1 - 2
    Lock switch not pushed
    10 kΩ or higher



NG
REPLACE BACK DOOR OPENER SWITCH (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BACK DOOR OPENER SWITCH)

  1. B171361E02
    Disconnect the certification ECU (smart key ECU assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-7 (TSW5) - h1-1 (L)
    Always
    Below 1 Ω
    D36-7 (TSW5) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK HARNESS AND CONNECTOR (BACK DOOR OPENER SWITCH - BODY GROUND)

  1. B164322E05
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    h1-2 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


← Back Door Entry Lock Function does not Operate (Aug 2008 – Jun 2010)PRECAUTION (May 2007 – Jul 2008) →