FAIL-SAFE CHART
System information · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jun 2010 from Jul 2010
If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
| DTC |
Component |
Fail-Safe Operation |
Fail-Safe Deactivation Condition |
| P0031, P0032, P0051 and P0052 |
Air fuel ratio sensor heater |
ECM turns off air fuel ratio sensor heater |
Ignition switch off |
| P0037, P0038, P0057 and P0058 |
Heated oxygen sensor heater |
ECM turns off heated oxygen sensor heater |
Ignition switch off |
| P0102 and P0103 |
Mass air flow meter sub-assembly |
ECM calculates ignition timing according to engine speed and throttle valve position |
Pass condition detected |
| P0112 and P0113 |
Intake air temperature sensor |
ECM estimates intake air temperature sensor to be 20°C (68°F) |
Pass condition detected |
| P0115, P0117 and P0118 |
Engine coolant temperature sensor |
ECM estimates engine coolant temperature sensor to be 80°C (176°F) |
Pass condition detected |
| P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135 |
Electronic throttle control system |
ECM cuts off throttle actuator current and throttle valve returned to 6° throttle position by return spring ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal opening angle, to allow vehicle to continue at minimal speed*1 |
Pass condition detected and then ignition switch turned off |
| P0300, P0301, P0302, P0303, P0304, P0305, P0306*2 |
|
When a misfire occurs, fuel cut is performed to prevent malfunction due to catalyst overheating.
|
Pass condition detected and then ignition switch turned off |
| P0327, P0328, P0332 and P0333 |
Knock Sensor |
ECM sets ignition timing to maximum retard |
Ignition switch off |
| P0351 to P0356 |
Igniter |
ECM cuts fuel |
Pass condition detected |
| P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138 |
Accelerator pedal position sensor |
Accelerator pedal position sensor has 2 sensor circuits: Main and Sub If either of circuits malfunctions, ECM controls engine using the other circuit If both of circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles |
Pass condition detected and then ignition switch turned off |
- NOTICE:
- *1: The vehicle can be driven slowly when the accelerator pedal is depressed slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.
- *2: Misfire related fail-safe operations occur when catalyst overheat malfunctions occur.