B1422/22 Compressor Lock Sensor Circuit
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
SYSTEM DESCRIPTION
The ECM sends the engine speed signal to the air conditioning amplifier via CAN communication.The air conditioning amplifier reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier determines that the compressor is locked, and turns the magnetic clutch off.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1422/22 |
Open or short in compressor lock sensor circuit |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK CAN COMMUNICATION SYSTEM |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- OK:
- CAN DTC is not output
|
|
||||
| OK | |
| 2. INSPECT AIR CONDITIONING AMPLIFIER |
Remove the air conditioning amplifier (Click here) with the connectors still connected.

Measure the waveform of the connector.

Item
Contents
Tool setting
200 mV/DIV., 10 ms./DIV.
Vehicle condition
Engine is running
Air conditioning switch: ON
Blower switch: LO
- Standard:
Tester Connection
Condition
Specified Condition
D33-8 (LOCK) - D33-13 (SG-2)
Engine is running
Air conditioning switch: ON
Blower switch: LO
Pulse generation
- Result:
Result
Proceed to
NG
A
OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE)
B
OK (When troubleshooting according to DTC)
C
|
|
||||
|
|
||||
| A | |
| 3. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR) |
Disconnect the connector from the air conditioning compressor.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B44-2 (SSR+) - B44-5 (SSR-)
20°C (68°F)
160 to 320 Ω
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - A/C LOCK SENSOR) |
Disconnect the connector from the air conditioning amplifier.

Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
D33-8 (LOCK) - B44-2 (SSR+)
Always
Below 1 Ω
D33-13 (SG-2) - B44-5 (SSR-)
Always
Below 1 Ω
D33-8 (LOCK) - Body ground
Always
10 kΩ or higher
D33-13 (SG-2) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
