2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT EXHAUST MANIFOLD SUB-ASSEMBLY LH

  1. A139214
    Using a precision straightedge and feeler gauge, measure the warpage on the contact surface of the cylinder head.

    Maximum warpage:
    0.7 mm (0.028 in.)

    HINT:
    The maximum allowable warpage of each installation surface is 0.3 mm (0.012 in.).

    If the warpage is greater than the maximum, replace the exhaust manifold sub-assembly LH.


INSPECT EXHAUST MANIFOLD SUB-ASSEMBLY RH

  1. A139215
    Using a precision straightedge and feeler gauge, measure the warpage on the contact surface of the cylinder head.

    Maximum warpage:
    0.7 mm (0.028 in.)

    HINT:
    The maximum allowable warpage of each installation surface is 0.3 mm (0.012 in.).

    If the warpage is greater than the maximum, replace the exhaust manifold sub-assembly RH.


INSPECT INTAKE AIR SURGE TANK ASSEMBLY

  1. A134935
    Using a precision straightedge and feeler gauge, measure the warpage on the contact surface of the intake manifold.

    Maximum warpage:
    2.5 mm (0.098 in.)
    If the warpage is greater than the maximum, replace the intake air surge tank assembly.


INSPECT INTAKE MANIFOLD

  1. A134934E01
    Cylinder head side:

    1. Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head for warpage.

      Maximum warpage:
      0.1 mm (0.003 in.)
      If the warpage is greater than the maximum, replace the intake manifold.

  1. intake air surge tank assembly side:

    1. Using a precision straightedge and feeler gauge, measure the surface contacting the intake air surge tank assembly for warpage.

      Maximum warpage:
      0.1 mm (0.003 in.)
      If the warpage is greater than the maximum, replace the intake manifold.

← REMOVAL (from Aug 2013)INSTALLATION (May 2007 – Jul 2008) →