2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from May 2007


CHECK TELEVISION DISPLAY ASSEMBLY
E119739E09
  1. Disconnect the television display assembly connector.

  2. Measure the voltage of the wire harness side connector.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    Q13-12 (GND6) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 V
    Q13-15 (ACC4) - Q13-12 (GND6)
    R - W-B
    Ignition (ACC)
    Ignition switch on (ACC)
    11 to 14 V
    Q13-16 (+B2) - Q13-12 (GND6)
    B - W-B
    Battery
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

← PROBLEM SYMPTOMS TABLE (from May 2007)A Remote Control System does not Operate (from May 2007) →