DATA LIST / ACTIVE TEST
System information · Vehicles built from May 2007
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
According to the display on the tester, read the "Data List".
Back Door (Power back door ECU) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Door Lock Status
Back door lock condition signal / LOCK or UNLOCK
LOCK: Back door is locked
UNLOCK: Back door is unlocked
-
Closer Position SW
Closer position switch signal / ON or OFF
ON: Back door lock center gear is center position
OFF: Back door lock center gear is not in center position
-
Courtesy SW
Back door courtesy switch signal / ON or OFF
ON: Back door is open
OFF: Back door is closed
-
Half Latch SW
Half-latch switch signal / ON or OFF
ON: Back door lock motor is open-latch or over-latch
OFF: Back door lock motor is full-latch or half-latch
-
MAIN BODY (Main body ECU) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
B Dor Handle
Back door open switch signal / ON or OFF
ON: Back door open switch is ON
OFF: Back door open switch is OFF
-
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
According to the display on the tester, perform the "Active Test".
Back Door (Power back door ECU) Tester Display
Test Part
Control Range
Diagnostic Note
PBD Motor
Power back door motor
ON / OFF
-
Latch Release
Power back door motor
ON / OFF
-