2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side.


2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure for the RH side and the LH side.


3. REMOVE DECK BOARD ASSEMBLY

  1. B173240
    Remove the deck board assembly.


4. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

  1. B173242
    Disengage the 2 guides and remove the No. 3 deck board sub-assembly.


5. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY

  1. B173244
    Disengage the 2 guides and remove the No. 2 deck board sub-assembly.


6. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
  1. Remove the tonneau cover assembly.


7. REMOVE REAR SEAT SIDE COVER LH

  1. B173607
    Disengage the 2 clips and remove the rear seat side cover LH.


8. REMOVE DECK SIDE TRIM BOX LH

  1. B173243E01
    Remove the 2 deck side trim clips and clip.

  1. Remove the deck side trim box LH as shown in the illustration.

    B178554


9. REMOVE REAR SEAT SIDE COVER RH

  1. B173608
    Disengage the 2 clips and remove the rear seat side cover RH.


10. REMOVE JACK CARRIER SUPPORT

11. REMOVE JACK CARRIER CUSHION (for LHD)

  1. B178550
    Remove the jack carrier cushion.


12. REMOVE JACK CARRIER CUSHION (for RHD)

  1. B178551
    Remove the jack carrier cushion.


13. REMOVE JACK ASSEMBLY (for LHD)

  1. B173245
    Remove the jack assembly.


14. REMOVE JACK ASSEMBLY (for RHD)

  1. B178566
    Remove the jack assembly.


15. REMOVE JACK CARRIER ASSEMBLY (for LHD)

  1. B178548
    Using a screwdriver, disengage the 3 claws and remove the jack carrier assembly.


16. REMOVE JACK CARRIER ASSEMBLY (for RHD)

  1. B179785
    Using a screwdriver, disengage the 3 claws and remove the jack carrier assembly.


17. REMOVE DECK SIDE TRIM BOX RH

  1. B173247E01
    Remove the 2 deck side trim clips and clip.

  1. Remove the deck side trim box RH as shown in the illustration.

    B178552


18. REMOVE REAR MAT

  1. B173249
    Remove the rear mat.


19. REMOVE DECK FLOOR BOARD ASSEMBLY

  1. B178561
    Disengage the 3 claws.

  1. Remove the 2 nuts and the deck floor board assembly.


20. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY

  1. B170935
    Remove the bolt and rear No. 2 seat inner belt assembly.

    HINT:
    Use the same procedure for the RH side and LH side.


21. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH

  1. B170936
    Remove the bolt and disconnect the rear seat lap type belt assembly LH.


22. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.


23. REMOVE REAR NO. 2 SEAT ASSEMBLY

  1. B173781
    Remove the 4 bolts and the rear No. 2 seat assembly.


24. REMOVE REAR FLOOR FINISH PLATE

  1. B173609
    Disengage the 4 clips and the 4 claws, and remove the rear floor finish plate.


25. REMOVE REAR SEAT SIDE GARNISH CAP

  1. B173616
    Remove the screw.

  1. Disengage the 6 claws and the guide, and remove the rear seat side garnish cap.


26. REMOVE DECK SIDE TRIM COVER NO.1

HINT:
Use the same procedure for the RH side and the LH side.


27. REMOVE DECK SIDE TRIM RH

HINT:
Use the same procedure for the RH side and the LH side.


28. REMOVE SIDE TRIM COVER RH (for Manual Air Conditioning System)

  1. B173610
    Disengage the 4 claws and remove the side trim cover RH.


29. REMOVE REAR ROOM TEMPERATURE SENSOR (for Automatic Air Conditioning System)

  1. E150364
    Disengage the 4 claws and remove the rear room temperature sensor.

  1. Disconnect the connector.


30. REMOVE REAR COMBINATION LIGHT SERVICE COVER RH

  1. B173618E01
    Using a screwdriver, disengage the 6 claws and the 2 guides, and remove the rear combination light service cover RH.

    HINT:
    Tape the screwdriver tip before use.


31. REMOVE ROPE HOOK ASSEMBLY (for RH Side)

HINT:
Use the same procedure for the RH side and the LH side.


32. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

HINT:
Use the same procedure for the No. 1 luggage compartment trim hook and the No. 2 deck side trim hook.


33. REMOVE FRONT DECK SIDE TRIM COVER RH

HINT:
Use the same procedure for the RH side and the LH side.


34. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
  1. Remove the 3 bolts.

  1. Remove the 2 clips.

  1. Disengage the 7 claws and 4 clips, and remove the deck trim side panel assembly RH.

    B173622


35. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.


36. REMOVE BLOWER MOTOR CONTROLLER

  1. E150361
    Disconnect the connector.

  1. Remove the 2 screws and the blower motor controller.

← COMPONENTS (from Jul 2010)REMOVAL (Aug 2008 – Jun 2010) →