Operate the cooler compressor at an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.
Stop the engine.
Recover the refrigerant from the A/C system using a refrigerant recovery unit.
2.
DISCONNECT REAR HEATER OUTLET WATER HOSE
Using pliers, grip the claws of the clip and slide the clip to disconnect the rear heater outlet water hose.
NOTICE:
Do not apply excessive force to the rear heater outlet water hose.
Prepare a drain pan or cloth in case the coolant leaks.
3.
DISCONNECT REAR HEATER INLET WATER HOSE
Using pliers, grip the claws of the clip and slide the clip to disconnect the rear heater inlet water hose.
NOTICE:
Do not apply excessive force to the rear heater inlet water hose.
Prepare a drain pan or cloth in case the coolant leaks.
4.
DISCONNECT COOLER REFRIGERANT LIQUID PIPE C
Remove the bolt, and slide the hook connector.
Disconnect the cooler refrigerant liquid pipe C.
Remove the O-ring from the cooler refrigerant liquid pipe C.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
5.
DISCONNECT COOLER REFRIGERANT SUCTION HOSE
Disconnect the rear cooler refrigerant suction hose.
Remove the O-ring from the rear cooler refrigerant suction hose.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
6.
REMOVE REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure for the RH side and the LH side.
7.
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
Use the same procedure for the RH side and the LH side.