2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

U0129 Lost Communication with Skid Control ECU

Diagnostic trouble codes · Vehicles built Jul 2010 – Jun 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

The combination meter assembly communicates with the skid control ECU via the CAN communication system (CAN No. 1 Bus).
DTC No.
DTC Detection Condition
Trouble Area
U0129
When either of following conditions detected:
  1. 15 seconds have elapsed since engine started and IG voltage 10.5 V or more
  2. No communication with skid control ECU continues for 3 seconds or more (No communication with ECM and skid control ECU continues for 60 seconds or more)
  1. Skid control ECU
  2. CAN communication system

WIRING DIAGRAM

E143765E07

INSPECTION PROCEDURE


1. CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Ignition switch on (IG).

  1. Turn the tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body Electrical / Trouble Codes.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is output.
    A
    DTC is not output.
    B

    HINT:
    If CAN communication system DTC U0129 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0129 first.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)


← U0129 Lost Communication with Skid Control ECU (Aug 2008 – Jun 2010)U0129 Lost Communication with Skid Control ECU (from Jul 2012) →