CUSTOMIZE PARAMETERS
Troubleshooting · Vehicles built from May 2007
- HINT:
- The following items can be customized.
- NOTICE:
- After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
- Be sure to record the current settings before customization.
- When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to "OFF", then perform troubleshooting).
- After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
| CUSTOMIZE |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Enter the following menus:
Select: Customize Setting /Select the setting by referring to the table below.
Power back door system Display (Item)
Default
Function
Setting
PBD SW Operation
0.8 s
Function that turns power back door closer switch ON when switch is pushed once or held down for 0.8 sec.
0.8s / ON
PBD Buzzer
ON
This function makes the power back door buzzer sound when power back door is operating
ON / OFF
Wirels PBD SW Operation
0.8 s
Function that operates power back door when transmitter switch is pressed in specified way
ON / 2 times / 0.8 s / OFF