B1447/47 Rear Air Mix Damper Control Servo Motor Circuit
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The rear air mix control servo motor sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the rear air mix damper to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.- HINT:
- Confirm that there are no mechanical problems because this DTC can be set if either a damper link or damper is mechanically locked.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1447/47 |
Rear air mix damper position does not change even if air conditioning amplifier operates rear air mix control servo motor |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (AIR MIX PULSE-R) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select the item below in the Data List, and read the value displayed on the intelligent tester.
Data List / Air Conditioner: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Air Mix Pulse-R
Rear air mix control servo motor target pulse /
Min.: 0, Max.: 255
- LHD:
MAX COLD: 9 (pulse)
MAX HOT: 54 (pulse)
- RHD:
MAX COLD: 9 (pulse)
MAX HOT: 54 (pulse)
-
- OK:
- The display is as specified in the normal condition column.
- Result:
Result
Proceed to
NG
A
OK (Checking from PROBLEM SYMPTOMS TABLE)
B
OK (Checking from DTC)
C
- LHD:
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING HARNESS - AIR CONDITIONING AMPLIFIER) |
Disconnect the N11 rear air conditioning harness connector.

Disconnect the D34 amplifier connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
N11-2 (RBUG) - D34-1 (RBUG)
Always
Below 1 Ω
N11-3 (RBUS) - D34-23 (RBUS)
Always
Below 1 Ω
N11-4 (RBBU) - D34-21 (RBBU)
Always
Below 1 Ω
D34-1 (RBUG) - Body ground
Always
10 kΩ or higher
D34-23 (RBUS) - Body ground
Always
10 kΩ or higher
D34-21 (RBBU) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. REPLACE REAR AIR MIX CONTROL SERVO MOTOR |
Replace the rear air mix control servo motor (Click here).
| NEXT | |
| 4. CHECK DTC OUTPUT |
Clear the DTC (Click here).
Check for DTC (Click here).
- OK:
- DTC B1447/47 is not output.
|
|
||||
| OK | ||
| ||
