2007-2013 Highlander Kluger · Service Manual BODY

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT POWER BACK DOOR OPENER / CLOSER SWITCH

B165199E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 1
    Pushed (ON)
    Below 1 Ω
    4 - 1
    Free (OFF)
    10 kΩ or higher

    If the result is not as specified, replace the switch.

  1. Check that the switch illuminates.

    Standard resistance:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 3 (ILL+)
    Battery negative (-) → 2 (ILL-)
    Illuminates

    If the result is not as specified, replace the switch.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →