2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Engine Switch Illumination Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The illuminated entry system controls the engine switch illumination.

WIRING DIAGRAM

E133241E06

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester on.

  1. Select the following menu items: Body Electrical / Main Body / Active Test.

  1. Check the operation.

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicator for Lighting
    Engine switch illumination
    ON / OFF
    -

    OK:
    Engine switch illumination comes on.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT ENGINE SWITCH

  1. Remove the engine switch.A109252E33

  1. Apply battery voltage to the engine switch.

  1. Check that the illumination comes on.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 5 (GND) or 4 (COM)
    Engine switch illumination comes on



NG
REPLACE ENGINE SWITCH
OK


3. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND)

  1. E121502E07
    Disconnect the D7 main body ECU connector.

  1. Disconnect the D22 engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D22-11 (SWIL) - D7-25 (SWIL)
    Always
    Below 1 Ω
    D22-4 (COM) or D22-5 (GND) - Body ground
    Always
    Below 1 Ω
    D22-11 (SWIL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Engine Switch Illumination Circuit (Aug 2008 – Jun 2010)Door Mirror Foot Light Circuit (May 2007 – Jul 2008) →