2007-2013 Highlander Kluger · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from May 2007

NOTICE:
If both the RH side hose and LH side hose are disconnected at the same time, be sure to place identification marks indicating the position on each side.

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. DRAIN BRAKE FLUID

2. REMOVE FRONT WHEEL

3. REMOVE FRONT FLEXIBLE HOSE

  1. C165870
    Remove the union bolt and gasket, and separate the front flexible hose.

  1. C165380E01
    Using a union nut wrench (10 mm), disconnect the brake line from the front flexible hose while holding the front flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake line.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake lines.

  1. C165382
    Remove the clip.

  1. C165383
    Remove the bolt and front flexible hose from the absorber bracket.

← COMPONENTS (from May 2007)INSTALLATION (May 2007 – Jun 2010) →