2007-2013 Highlander Kluger · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE BRAKE MASTER CYLINDER TO WAY TUBE

  1. C165949
    Mount the brake master cylinder sub-assembly in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

  1. Using a union nut wrench (12 mm), remove the brake master cylinder to way tube from the No. 2 brake tube way and brake master cylinder body.


2. REMOVE NO. 2 BRAKE TUBE WAY
  1. Remove the No. 2 brake tube way from the brake master cylinder body.


3. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

  1. C165948
    Mount the brake master cylinder sub-assembly in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

  1. Using a pin punch and a hammer, tap out the straight pin, and remove the brake master cylinder reservoir assembly.


4. REMOVE MASTER CYLINDER RESERVOIR GROMMET
  1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.

← REMOVAL (from Jul 2010)INSPECTION (from May 2007) →