2007-2013 Highlander Kluger · Service Manual BODY

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT BACK DOOR OPENER SWITCH ASSEMBLY

  1. Check operation of the opener switch.

    1. Measure the resistance according to the value(s) in the table below.

      B171359E06

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      2 - 3
      Back door opener switch not pushed (OFF)
      10 kΩ or higher
      2 - 3
      Back door opener switch pushed (ON)
      Below 1 Ω

      If the result is not specified, replace the back door opener switch assembly.

  1. Check operation of the lock switch (w/ Smart Entry and Start System).

    1. B171360E01
      Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      1 - 2
      Lock switch pushed (ON)
      Below 1 Ω
      1 - 2
      Lock switch not pushed (OFF)
      10 kΩ or higher

      If the result is not specified, replace the back door opener switch assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →