2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. INSTALL ELECTRICAL ANTENNA KEY

  1. B172701
    Install the electrical antenna key with the 2 nuts.

  1. Connect the connector.


2. INSTALL REAR BUMPER ASSEMBLY (w/ Rear Fog Light)
  1. Connect the rear fog light connector, and then install the rear bumper assembly.

  1. B175998
    Engage the 8 claws.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B172735
    Install the 5 clips, 8 screws and 2 bolts.


3. INSTALL REAR BUMPER ASSEMBLY (w/ Rear Fender Mudguard)

  1. B175296
    Engage the 8 claws and install the rear bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B180435
    Install the 5 clips, 6 screws and 2 bolts.


4. INSTALL REAR QUARTER PANEL MUDGUARD LH (w/ Rear Fender Mudguard)

  1. B172720E01
    Install the screw (A).

  1. Using a 4 mm hexagon wrench, install the 6 screws (B).


5. INSTALL REAR QUARTER PANEL MUDGUARD RH (w/ Rear Fender Mudguard)

HINT:
Use the same procedures for the RH side and LH side.

← REMOVAL (from Jul 2010)INSTALLATION (from Jul 2010) →