2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR QUARTER PANEL MUDGUARD LH (w/ Rear Fender Mudguard)

  1. B172720E01
    Remove the screw (A).

  1. Using a 4 mm hexagon wrench, remove the 6 screws (B).


2. REMOVE REAR QUARTER PANEL MUDGUARD LH

HINT:
Use the same procedures for the RH side and LH side.


3. REMOVE REAR BUMPER ASSEMBLY (w/ Rear Fender Mudguard)

  1. B172734E01
    Put protective tape around the rear bumper assembly.

  1. B180435
    Remove the 5 clips, 6 screws and 2 bolts.

  1. B172733
    Disengage the 8 claws and disconnect the rear bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the rear bumper assembly.


4. REMOVE REAR BUMPER ASSEMBLY (w/ Rear Fog Light)

  1. B172737E01
    Put protective tape around the rear bumper assembly.

  1. B172735
    Remove the 5 clips, 8 screws and 2 bolts.

  1. B172736
    Disengage the 8 claws and disconnect the rear bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect the rear fog light connector, and then remove the rear bumper assembly.


5. REMOVE ELECTRICAL ANTENNA KEY

  1. B172701
    Disconnect the connector.

  1. Remove the 2 nuts and the electrical antenna key.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →