REMOVAL
Removal / installation · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
|
 |
- Apply protective tape to the areas shown in the illustration.
Using a moulding remover, disengage the 10 claws and 8 clips starting from the upper part of the center instrument cluster finish panel assembly.
- NOTICE:
- Do not pull on the small storage compartment lid. Doing so may cause damage.
Disconnect each connector and remove the center instrument cluster finish panel assembly.
| 2.
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
- Disengage the 4 claws and 4 clips.
Disconnect the connector and remove the upper console panel sub-assembly.
| 3.
REMOVE NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System)
|
 |
- Remove the No. 2 console box duct as shown in the illustration.
| 4.
REMOVE LOWER REAR CONSOLE BOX
|
 |
Remove the lower rear console box.
| 5.
REMOVE CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System)
|
 |
- Remove the 4 bolts and 2 screws.
- Disengage the 6 claws and remove the console box assembly.
| 6.
REMOVE CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System)
|
 |
- Remove the 4 bolts and 2 screws.
- Disconnect the connector.
Disengage the 6 claws, and remove the console box assembly.
| 7.
REMOVE ELECTRICAL KEY OSCILLATOR |
 |
- Disconnect the connector.
Disengage the clamp and remove the electrical key oscillator.