2007-2013 Highlander Kluger · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. CONNECT WASHER HOSE ASSEMBLY

  1. B172910
    Connect the washer hose assembly.


2. ADJUST WASHER NOZZLE SUB-ASSEMBLY

  1. Select a washer nozzle sub-assembly so that the washer fluid spray area is as specitied.

    E150188E01


3. INSTALL WASHER NOZZLE SUB-ASSEMBLY

  1. E128831
    Connect a new washer nozzle sub-assembly to the washer hose.

  1. B163611E01
    Engage the 2 claws and install the washer nozzle sub-assembly as shown in the illustration.


4. INSTALL HOOD INSULATOR

  1. B257318
    Install the hood insulator with the 8 clips.


5. INSTALL HOOD TO RADIATOR SUPPORT SEAL

  1. B257317
    Install the hood to radiator support seal with the 8 clips.


6. INSPECT FRONT WASHER NOZZLE SUB-ASSEMBLY

  1. With the engine running, check the positions that the washer fluid hits the windshield.

    E150189E01

    Area
    Dimension
    A
    353 mm (13.88 in.)
    B
    143 mm (5.70 in.)
    C
    193 mm (7.61 in.)

    OK:
    Washer fluid hits the windshield in the areas shown in the illustration.

    HINT:
    If the result is not as specified, replace the washer nozzle.

← REASSEMBLY (May 2007 – Jun 2010)COMPONENTS (May 2007 – Jun 2010) →