PRECAUTION
Precautions · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable from negative (-) battery terminal, initialize the following system after the cable is reconnected.
System Name
See Procedure
Power Back Door System
Click here
| 2.EXPRESSIONS OF IGNITION SWITCH |
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Switch Type
Ignition Switch
(Position)
Engine Switch
(Condition)
Expression
Ignition Switch off
LOCK
Off
Ignition Switch ON
ON
On (IG)
Ignition Switch ACC
ACC
On (ACC)
Engine Start
START
Start
| 3.NOTES FOR REAR VIEW MONITOR |
Notes for the television camera assembly
The rear view monitor system may not function properly if subjected to a severe blow by any hard object.
Do not scrub the camera (resin made). Scrubbing may scratch the camera and affect the image. Prevent organic solvents, waxes, bond removing solvents or glass coating from adhering to the camera. If such material adheres to the camera, clean it off immediately and wash with water.
Exposing the camera to a sudden temperature change may affect proper functioning of the camera.
A clear image may not appear if the camera is dirty with snow, mud, etc. In that case, wash it with water and wipe off the lens. Use a detergent to remove dirt if necessary.
Images may be unclear even in normal conditions if:
Electrical devices that generate interference are used in the cabin.
Accessories that generate radio waves have been installed.
The camera lens is frosted over (the image immediately after turning the ignition switch to ON may be blurred or darker than normal).
The camera lens is dirty with snow, mud, etc.
A strong beam of light, such as a sunbeam or headlight, hits the camera.
It is too dark around the camera (at night etc.).
The ambient temperature around the camera is either too high or too low.
The vehicle is tilted at a steep angle.
The ambient light surrounding the camera is too bright. (When a strong light, such as a sunbeam reflected off the vehicle body, hits the camera, the image may be blurred. This is called the "SMEAR" phenomenon, peculiar to the CCD camera.)
When the camera is used under fluorescent light, sodium lights, or mercury lights etc., the lights and the illuminated areas may appear to flicker.