2007-2013 Highlander Kluger · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSTALL OIL PUMP COVER

  1. A128010E02
    Coat the drive and driven rotors with engine oil and place them into the timing chain cover with the marks facing up (oil pump cover side). Check that the rotors rotate smoothly.

  1. A094627E02
    Install the oil pump cover with the 8 bolts.

    Torque:
    9.1 N*m{ 93 kgf*cm , 81 in.*lbf }

    Bolt length 
    Item
    Length
    Bolt A
    22 mm (0.87 in.)
    Bolt B
    40 mm (1.58 in.)


2. INSTALL OIL PUMP RELIEF VALVE

  1. A128008
    Coat the oil pump relief valve with engine oil.

  1. Insert the relief valve and relief valve spring into the oil pump cover hole.

  1. Using a 27 mm socket wrench, install the plug.

    Torque:
    49 N*m{ 500 kgf*cm , 37 ft.*lbf }

← INSPECTION (from May 2007)INSTALLATION (May 2007 – Jul 2008) →