2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT VACUUM SWITCHING VALVE ASSEMBLY

  1. A075331E02
    Inspect VSV operation.

    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      37 to 44 Ω

      If the result is not as specified, replace the VSV.

  1. Inspect the VSV for a short to ground.

    1. A075332E03
      Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - Body ground
      20°C (68°F)
      10 kΩ or higher
      2 - Body ground
      20°C (68°F)
      10 kΩ or higher

      If the result is not as specified, replace the VSV.

  1. A126855E01
    Inspect VSV operation.

    1. Check that air flows from port E to the filter.

    2. Apply battery voltage across the terminals.

    3. Check that air flows from port E to port F.
      If operation is not as specified, replace the VSV.

← REMOVAL (from May 2007)INSTALLATION (from May 2007) →