INSPECTION
Inspection · Vehicles built from May 2007
| INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY |


Inspect the EFI No. 1 fuse.
Remove the EFI No. 1 fuse.
Using an ohmmeter, measure the resistance of the fuse.
- Standard resistance:
Tester Connection
Condition
Specified Condition
EFI No. 1 fuse
Always
Below 1 Ω
Inspect the A/F fuse.
Remove the A/F fuse.
Using an ohmmeter, measure the resistance of the fuse.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A/F fuse
Always
Below 1 Ω
Inspect EFI relay.
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
2E-12 - 2E-7
No battery voltage applied
10 kΩ or higher
2E-12 - 2E-7
Battery voltage applied to terminals 2E-10 and 2E-9
Below 1 Ω
- NOTICE:
- While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
Inspect the C/OPN relay.
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
2E-13 - 2E-7
No battery voltage applied
10 kΩ or higher
2E-13 - 2E-7
Battery voltage applied to terminals 2E-8 and 2D-12
Below 1 Ω
- NOTICE:
- While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
Inspect the A/F relay.
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
2A-4 - 2C-1
No battery voltage applied
10 kΩ or higher
2A-4 - 2C-1
Battery voltage applied to terminals 2E-10 and 2E-7
Below 1 Ω
- NOTICE:
- While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
