2007-2013 Highlander Kluger · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. POSITION FRONT WHEELS STRAIGHT AHEAD

2. ADJUST SPIRAL CABLE
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) cable is disconnected.

    CAUTION:
    Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

  1. C165096
    Rotate the spiral cable counterclockwise slowly by hand until it stops.

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.

  1. C165097E01
    Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.


3. INSTALL STEERING WHEEL ASSEMBLY

  1. C165708E01
    Align the matchmarks on the steering wheel assembly and steering main shaft.

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect the connectors to the spiral cable sub-assembly.


4. INSTALL STEERING PAD
(Click here)

5. INSPECT STEERING WHEEL CENTER POINT

6. INSPECT SRS WARNING LIGHT
(Click here)
← INSTALLATION (Aug 2008 – Jun 2010)PRECAUTION (May 2007 – Jul 2008) →