2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from May 2007


CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

  1. Disconnect the 1D, 1F junction block and and D7, D9 ECU connectors.
    B139428E11

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1F-10 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1D-10 (BECU) - Body ground
    W - Body ground
    Power Source
    Always
    11 to 14 V
    D7-24 (DCTY)*1 - Body ground
    G - Body ground
    Driver door courtesy light switch signal
    Switch pushed (Door closed)
    10 kΩ or higher
    Switch free (Door opened)
    Below 1 Ω
    D7-24 (DCTY)*2 - Body ground
    SB - Body ground
    Driver door courtesy light switch signal
    Switch pushed (Door closed)
    10 kΩ or higher
    Switch free (Door opened)
    Below 1 Ω
    D9-5 (KSW) - Body ground
    GR - Body ground
    Key unlock warning switch signal
    No key is in ignition key cylinder
    10 kΩ or higher
    Key is in ignition key cylinder
    Below 1 Ω

    HINT:
    *1: for LHD
    *2: for RHD

    HINT:
    If the result is not as specified, there may be a malfunction on the wire harness side.

← PROBLEM SYMPTOMS TABLE (from Jul 2012)DIAGNOSIS SYSTEM (from May 2007) →