2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built from May 2007


READ DATA LIST

HINT:
Using an intelligent tester to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus: Body / MAIN BODY / Data List.

  5. According to the display on the tester, read the "Data List".

    MAIN BODY 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch signal / ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -
    D Door Courtesy SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -

← DIAGNOSIS SYSTEM (from May 2007)Key Reminder Buzzer does not Sound (May 2007 – Jul 2008) →