2007-2013 Highlander Kluger · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The following procedure is for the LH side.
  3. If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear speed sensor.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)


2. REMOVE REAR WHEEL

3. SEPARATE REAR SPEED SENSOR WIRE

  1. C167422
    Using a screwdriver, disconnect the connector from the rear speed sensor.

    NOTICE:
    Be careful not to damage the rear speed sensor.


4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

  1. C167785
    Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


5. REMOVE REAR DISC

  1. C166438E01
    Put matchmarks on the rear disc and the axle hub.

  1. D028126
    Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.


6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH REAR SPEED SENSOR

  1. C167786
    Remove the 4 bolts and the rear axle hub and bearing assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.


7. REMOVE REAR SPEED SENSOR
  1. Install the 3 hub nuts and mount the rear axle hub and bearing assembly in a vise using aluminum plates.

    NOTICE:
    Replace the rear axle hub and bearing assembly if it is dropped or receives a strong shock.

  1. C165851E01
    Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
    SST
    09520-00031   (09521-00010, 09520-00040)
    09521-00020  

  1. C167420E01
    Using SST and 2 bolts (diameter: 12 mm, pitch: 1.5 mm), remove the rear speed sensor from the rear axle hub and bearing assembly.
    SST
    09520-00031   (09521-00010, 09520-00040)
    09521-00020  
    09950-00020  

    NOTICE:
    1. Keep the rear speed sensor away from magnets.
    2. Pull the rear speed sensor off straight, taking care not to allow it to be in contact with the rear speed sensor rotor.
    3. If the rear speed sensor rotor is damaged or deformed, replace the rear axle hub and bearing assembly.
    4. Do not scratch the contact surface between the rear axle hub and bearing assembly and the rear speed sensor.
    5. Prevent foreign matter from attaching to the rear speed sensor rotor or tip.

    HINT:
    If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear speed sensor.

← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →