REMOVAL
Removal / installation · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
PRECAUTION |
 |
(Click here)
| 2.
FRONT WHEELS FACING STRAIGHT AHEAD |
|
| 3.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)
| 4.
REMOVE LOWER NO. 3 STEERING WHEEL COVER
|
 |
- Disengage the claw and remove the lower No. 3 steering wheel cover.
| 5.
REMOVE LOWER NO. 2 STEERING WHEEL COVER
|
 |
- Disengage the claw and remove the lower No. 2 steering wheel cover.
| 6.
REMOVE STEERING PAD
|
 |
- Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
- Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
- Disconnect the horn connector from the steering pad.
Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 7.
REMOVE STEERING WHEEL ASSEMBLY
|
 |
- Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and the steering main shaft.
Disconnect the connectors from the spiral cable.
- Using SST, remove the steering wheel assembly.
- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05021)
- NOTICE:
- Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
| 8.
REMOVE STEERING COLUMN COVER
|
 |
- Remove the 2 screws.
- Disengage the 2 claws to remove the lower steering column cover.
- Disengage the claw to remove the upper steering column cover.
| 9.
REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR
|
 |
- Disconnect the connectors from the spiral cable with steering angle sensor.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Disengage the 3 claws and remove the spiral cable with steering angle sensor.
| 10.
REMOVE STEERING ANGLE SENSOR |
 |
- Disengage the 6 claws and 2 pins, and remove the steering angle sensor from the spiral cable.