2007-2013 Highlander Kluger · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT VSC OFF SWITCH

  1. C151980E04
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 6
    Switch is not pushed in
    10 kΩ or higher
    3 - 6
    Switch is pushed in
    Below 25 Ω

    If the result is not as specified, replace the switch.

  1. Check the illumination operation.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 5
    Battery's positive (+) lead connected to terminal 5 and negative (-) lead to terminal 4
    LED illuminates

    If the result is not as specified, replace the switch.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →