2007-2013 Highlander Kluger · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. INSTALL FRONT BUMPER ASSEMBLY
  1. Connect each fog light connector, and then install the front bumper assembly.

  1. B258279
    Engage the 5 claws.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the 3 clips and 8 screws.

  1. B258276E01
    Install the screw and 2 pin hold clips.
    Text in Illustration 
    *1
    Correct
    *2
    Incorrect

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

    HINT:
    Use the same procedure for the RH side and LH side.


2. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

  1. B258272
    Engage the 2 guides and 8 claws, and install the radiator grille sub-assembly.

  1. Install the 6 clips.


3. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 11 clips.


4. ADJUST FOG LIGHT AIMING (w/ Fog Light)
(Click here)
← INSTALLATION (May 2007 – Jun 2010)COMPONENTS (May 2007 – Jun 2010) →