REMOVAL
Removal / installation · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
REMOVE ENGINE UNDER COVER ASSEMBLY
|
 |
- Remove the 2 bolts and engine under cover assembly RR.
- Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.
| 2.
REMOVE NO. 1 ENGINE UNDER COVER
|
 |
- Remove the 6 bolts, 2 clips and No. 1 engine under cover.
| 3.
REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
 |
- Remove the clip.
Using a 4 mm hexagon wrench, remove the screw.
- Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.
Remove the pad from the front fender moulding sub-assembly.
Remove the 2 No. 4 clips from the front fender moulding sub-assembly.
- Remove the front fender side protector from the front fender moulding sub-assembly.
| 4.
REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH |
 |
- HINT:
- Use the same procedures for the RH side and LH side.
| 5.
REMOVE FRONT WHEEL OPENING EXTENSION PAD (for LH Side) |
 |
- Remove the 2 screws and front wheel opening extension pad.
| 6.
REMOVE FRONT WHEEL OPENING EXTENSION PAD (for RH Side) |
 |
- HINT:
- Use the same procedure for the RH side and LH side.
| 7.
REMOVE FRONT FENDER LINER LH |
 |
- Remove the screw.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- Using a 4 mm hexagon wrench, remove the 2 screws.
Remove the 2 grommets.
- HINT:
- The grommets need to be replaced with new ones because they will break when they are removed.
- Remove the 5 clips, 8 screws and front fender liner LH.
| 8.
REMOVE FRONT FENDER LINER RH |
 |
- Remove the screw.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- Using a 4 mm hexagon wrench, remove the 2 screws.
Remove the 2 grommets.
- HINT:
- The grommets need to be replaced with new ones because they will break when they are removed.
- Remove the 5 clips, 7 screws and front fender liner RH.