2007-2013 Highlander Kluger · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT DOWNHILL ASSIST CONTROL SWITCH

  1. C165841E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch is not pushed in
    10 kΩ or higher
    1 - 4
    Switch is pushed in
    Below 1 Ω

    If the result is not as specified, replace the downhill assist control switch.

  1. Check the illumination operation.

    1. Connect a battery positive (+) lead to terminal 3 and negative (-) lead to terminal 2. Then check that the bulb in the switch illuminates.

      OK:
      Bulb illuminates.

      If the result is not as specified, replace the downhill assist control switch.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →