ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| INSPECT BRAKE PEDAL LOAD SENSING SWITCH |
- NOTICE:
- Do not remove the brake pedal load sensing switch from the brake pedal support.
- When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support.
- Do not remove the brake pedal load sensing switch from the brake pedal support.
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the brake pedal load sensing switch connector.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
2 (FSW+) - 1 (GND)
Brake pedal load sensing switch OFF (Brake pedal depressed)
950 to 1050 Ω
2 (FSW+) - 1 (GND)
Brake pedal load sensing switch ON (Brake pedal released)
203 to 223 Ω
