2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. INSTALL FOG LIGHT ASSEMBLY

  1. E212220
    Engage the 3 claws and pin to install the fog light assembly.


2. INSTALL FOG LIGHT COVER

  1. B258281
    Engage the 7 claws and guide to install the fog light cover LH.

  1. B258283
    Engage the claw to install the outside moulding retainer.


3. INSTALL FRONT BUMPER ASSEMBLY
  1. Connect each fog light connector, and then install the front bumper assembly.

  1. B258279
    Engage the 5 claws.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the 3 clips and 8 screws.

  1. B258276E01
    Install the screw and 2 pin hold clips.
    Text in Illustration 
    *1
    Correct
    *2
    Incorrect

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

    HINT:
    Use the same procedure for the RH side and LH side.


4. INSTALL RADIATOR GRILLE

  1. B258272
    Engage the 2 guides and 8 claws, and install the radiator grille sub-assembly.

  1. Install the 6 clips.


5. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 11 clips.


6. ADJUST FOG LIGHT AIMING
(Click here)
← INSTALLATION (May 2007 – Jun 2010)COMPONENTS (May 2007 – Jun 2010) →