2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B258270
    Remove the 11 clips and cool air intake duct seal.


2. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

  1. B258273E01
    Put protective tape around the radiator grille sub-assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. B258271
    Remove the 6 clips.

  1. Disengage the 8 claws and 2 guides, and remove the radiator grille sub-assembly.


3. REMOVE FRONT BUMPER ASSEMBLY

  1. B258274E01
    Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. B258275E01
    Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B258277
    Remove the 8 screws and 3 clips.

  1. B258278
    Disengage the 5 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each fog light connector, and then remove the front bumper assembly.


4. REMOVE FOG LIGHT COVER

  1. B258282
    Disengage the claw and remove the outside moulding retainer.

  1. B258281
    Disengage the 7 claws, guide and remove the fog light cover LH.


5. REMOVE FOG LIGHT ASSEMBLY

  1. E212219E01
    Using a screwdriver, disengage the claw (A).

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. Disengage the 2 claws (B) and pin, and remove the fog light assembly.

← REMOVAL (May 2007 – Jun 2010)DISASSEMBLY (May 2007 – Jun 2010) →