REMOVAL
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait for 90 seconds after disconnecting the terminal to prevent airbag deployment (Click here).
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE LOWER NO. 3 STEERING WHEEL COVER
|
 |
- Disengage the claw and remove the lower No. 3 steering wheel cover.
| 3.
REMOVE LOWER NO. 2 STEERING WHEEL COVER
|
 |
- Disengage the claw and remove the lower No. 2 steering wheel cover.
| 4.
REMOVE STEERING PAD
|
 |
- Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
- Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
- Disconnect the horn connector from the steering pad.
Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 5.
REMOVE STEERING PAD SWITCH ASSEMBLY |
 |
- Disconnect the pad switch connector from the spiral cable.
Remove the screw.
Disengage the 2 pins and remove the steering pad switch.
- Remove the screw.
Disengage the 2 pins and remove the steering pad switch assembly.