2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL CLOCK ASSEMBLY

2. INSTALL NO. 2 RADIO BRACKET

  1. E151798
    Install the No. 2 radio bracket with the 4 screws.


3. INSTALL NO. 1 RADIO BRACKET

  1. E151799
    Install the No. 1 radio bracket with the 4 screws.

  1. E150546
    Engage the claw and install the connector.


4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
  1. Connect each connector.

  1. E150552
    Engage the 4 clips.

  1. E150551
    Install the radio receiver assembly with bracket with the 4 bolts.


5. INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY
  1. Connect the connector.

  1. E150368
    Engage the 4 clips and install the heater control and accessory assembly.


6. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

  1. B184679E01
    Apply protective tape to the areas shown in the illustration.

  1. Connect each connector.

  1. Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.

    NOTICE:
    Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.


7. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

  1. B168369
    Engage the 2 claws and 5 clips, and install the center instrument panel register assembly.

← INSTALLATION (Aug 2008 – Jun 2010)COMPONENTS (from May 2007) →