2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT ENTRY LOCK SWITCH (for Back Door)

  1. B171360E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Lock switch pushed
    Below 1 Ω
    1 - 2
    Lock switch not pushed
    10 kΩ or higher

    If the result is not specified, replace the entry lock switch.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →