2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side.


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.


3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

  1. B172999
    Disengage the 3 claws.

  1. Disengage the 2 guides and remove the No. 2 instrument panel under cover sub-assembly.


4. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

  1. B168370
    Remove the 2 bolts <B> and 3 screws <E>.

  1. Disengage the 4 claws and 3 clips.

  1. Disconnect each connector and clamp, and remove the lower instrument panel sub-assembly.


5. REMOVE ECM (for RHD)

  1. A238446E01
    Disconnect the 6 ECM connectors.

  1. Separate the 2 wire harness clamps (for LHD).

  1. Remove the wire harness clamp (for RHD).

  1. Remove the 2 nuts, bolt and ECM with the ECM bracket.

  1. A238413E01
    Remove the 4 screws and 2 ECM brackets from the ECM.


6. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

  1. E150334
    Disconnect each connector.

  1. Remove the 2 screws and the air conditioning amplifier assembly.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →