2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL REAR SPEAKER ASSEMBLY

  1. E150558
    Connect the connector.

  1. Install the rear speaker assembly with the 3 bolts.

    NOTICE:
    Do not touch the cone part of the speaker.


2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B173158
    Connect the rear door lock remote control cable and rear door inside locking cable to the rear door inside handle sub-assembly.

  1. Engage the 2 clamps.

  1. B173156
    Engage the rear door trim board with the 5 claws on the rear door inner glass weatherstrip.

  1. Engage the 9 clips and install the rear door trim board to the rear door panel.

  1. B173155E01
    Install the 2 screws <B>.

  1. Install the screw <A>.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }


3. INSTALL DOOR ASSIST GRIP COVER

  1. B172990
    Engage the 4 claws and install the door assist grip cover.


4. INSTALL REAR DOOR ARMREST UPPER BASE PANEL
  1. Connect the connector.

  1. B172988
    Engage the 6 claws and 2 clips and install the rear door armrest upper base panel.


5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

  1. B172921
    Engage the 3 claws to install the rear door inside handle bezel plug.

← INSTALLATION (May 2007 – Jul 2008)INSTALLATION (from Jul 2010) →