2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL STEERING PAD SWITCH ASSEMBLY

  1. E150586
    Engage the 2 pins and install the steering pad switch.

  1. Install the screw.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. E150585
    Engage the 2 pins and install the steering pad switch assembly.

  1. Install the screw.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the pad switch connector to the spiral cable.


2. INSTALL STEERING PAD
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    CAUTION:
    Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

  1. C165092
    Support the steering pad with one hand as shown in the illustration.

  1. C165093
    Connect the 2 airbag connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector to the steering pad.

  1. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. C166982E01
    Using a "TORX" socket wrench (T30), tighten the 2 "TORX" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }


3. INSTALL LOWER NO. 3 STEERING WHEEL COVER

  1. C165090
    Install the lower No. 3 steering wheel cover with the claw.


4. INSTALL LOWER NO. 2 STEERING WHEEL COVER

  1. C165091
    Install the lower No. 2 steering wheel cover with the claw.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


6. INSPECT STEERING PAD

  1. C166979
    With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
    1. Cuts, minute cracks or marked discoloration on the steering pad top surface or grooves.

  1. Make sure that the horn sounds.

    HINT:
    If the horn does not sound, inspect the horn system (Click here).


7. INSPECT SRS WARNING LIGHT
(Click here)
← INSTALLATION (Aug 2008 – Jun 2010)COMPONENTS (from May 2007) →