2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


INSPECT STEERING PAD SWITCH ASSEMBLY

  1. Disconnect the steering pad switch assembly connector.

    E136177E23

  1. Measure the resistance according to the values in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specified condition
    AU1 - EAU
    No switch is pushed
    95 to 105 kΩ
    AU1 - EAU
    Seek+ switch: pushed
    Below 2.5 Ω
    AU1 - EAU
    Seek- switch: pushed
    312 to 345 Ω
    AU1 - EAU
    Volume+ switch: pushed
    950 to 1050 Ω
    AU1 - EAU
    Volume- switch: pushed
    2954 to 3265 Ω
    AU2 - EAU
    No switch is pushed
    95 to 105 kΩ
    AU2 - EAU
    MODE switch: pushed
    Below 2.5 Ω
    AU2 - EAU
    Voice switch: pushed*1
    2954 to 3265 Ω
    AU2 - EAU
    On hook switch: pushed*1
    312 to 345 Ω
    AU2 - EAU
    Off hook switch: pushed*1
    950 to 1050 Ω

    1. *1: w/ Telephone Microphone Assembly
    Text in Illustration 
    *A
    w/ Telephone Microphone Assembly
    *a
    Component without harness connected
    (Steering Pad Switch Assembly)
    *b
    Volume+
    *c
    Volume-
    *d
    Seek-
    *e
    MODE
    *f
    Seek+
    *g
    On hook
    *h
    Off hook
    *i
    Voice
    If the result is not as specified, replace the steering pad switch assembly.

← INSPECTION (May 2007 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →