INSTALLATION
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL NAVIGATION RECEIVER ASSEMBLY |
|
| 2.
INSTALL NO. 2 RADIO BRACKET |
 |
- Install the No. 2 radio bracket with the 6 screws.
| 3.
INSTALL NO. 1 RADIO BRACKET |
 |
- Install the No. 1 radio bracket with the 6 screws.
- Engage the claw and connect the connector.
| 4.
INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET |
 |
Connect each connector.
- Engage the 4 clips.
- Install the navigation receiver assembly with bracket with the 4 bolts.
| 5.
INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)
|
 |
Connect the connector.
- Engage the 4 clips and install the heater control and accessory assembly.
| 6.
INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
|
 |
Connect the connector.
- Engage the 4 clips and install the air conditioning control assembly.
| 7.
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Entry and Start System)
|
 |
- Apply protective tape to the areas shown in the illustration.
Connect each connector.
Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.
- NOTICE:
- Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.
| 8.
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Entry and Start System)
|
 |
- Apply protective tape to the areas shown in the illustration.
Connect each connector.
Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.
- NOTICE:
- Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.
| 9.
INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
|
 |
- Engage the 2 claws and 5 clips, and install the center instrument panel register assembly.
| 10.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD) |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).